Q110 Clamp Adaptor 1000A Current Sensor Clamp on Current Transformer
The model Q110 1000A Current Sensor Clamp on Current Transformer is a high accuracy ct, the advanced design ensures enhanced linearity and the jaw opening system provides enhanced safety.
FEATURES
This product can be used in large current situation; also can cooperate to cable fault tester and cable identification device, used for cable test work.
Holding wire diameter: φ110mm
Dimension: 163mm×310mm×34mm
Load capacity: mA output≤4Ω, 1A output 0.1Ω, 5A output 2.5VA
Installation: clamp type
Output mode: lead output
PARAMETERS
The model Q110 1000A Current Sensor Clamp on Current Transformer is a high accuracy ct, the advanced design ensures enhanced linearity and the jaw opening system provides enhanced safety.
FEATURES
This product can be used in large current situation; also can cooperate to cable fault tester and cable identification device, used for cable test work.
Holding wire diameter: φ110mm
Dimension: 163mm×310mm×34mm
Load capacity: mA output≤4Ω, 1A output 0.1Ω, 5A output 2.5VA
Installation: clamp type
Output mode: lead output
PARAMETERS
Electrical parameters | |
---|---|
Ratio | 1000: 1 or 2000:1 (customized) |
Accuracy class | 0.2%, 0.5% |
Primary current | 0 - 1000A AC |
Secondary current | 0 - 5A AC (customized) |
Output signal | 500mA,1A,5A AC at nominal input current |
Frequency range | 40Hz-2000Hz |
Dielectric strength | 3KV 50Hz/60Hz at 1 minute |
Temperature range | -20°C to +55°C |
Output | 2.5 meter cable with D01 connector |
Max. voltage not insulated conductors | 600 V |
Standard | EN 61010-1, EN 61010-2-032 |
Installation | clamp type |
Output mode | lead output(2.5m) |
Mechanical parameters | |
Dimensions (L x W x H) (mm) | 163 x 310 x 34 |
Weight (g) | 900 |
Holding wire diameter (mm) | φ110 |
Max. jaw opening (mm) | 110 |